Rim-hanging enclosure for a pump relay module, with a filleted shell, chamfered lip, hook that clamps the planter wall and a side slot for wire exit.
This part prints on its own but is designed as one assembly. The other 3 parts:
Rim-hanging enclosure for a pump relay module, with a filleted shell, chamfered lip, hook that clamps the planter wall and a side slot for wire exit.
62 × 39 × 26 mm
“Design a small electronics dock that hangs on the rim of a planter and holds a relay module, with a hook that clamps over the wall and a slot for the wires to exit.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
62 × 39 × 26 mm
Material
PLA
Print Time
1h 55m
Filament
23g
Mesh Faces
1.0k
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Jigsaw-tabbed 95 mm coaster that keys into its neighbours on two edges with a 0.2 mm fit tolerance, with three concentric drip-catch grooves on the face.
PLA · 4h 40m
Upright caddy sized for a stack of the interlocking coasters, with filleted corners and a front cutaway so the top coaster can be thumbed out.
PLA · 3h 5m
Screw-mounted wall hook on a rounded 60x95 mm backplate with five hexagonal cutouts, two countersunk holes and a 45-degree support wedge so it prints flat on its back.
PLA · 4h 5m