Upright caddy sized for a stack of the interlocking coasters, with filleted corners and a front cutaway so the top coaster can be thumbed out.
Upright caddy sized for a stack of the interlocking coasters, with filleted corners and a front cutaway so the top coaster can be thumbed out.
103 × 30 × 45 mm
“Make an upright holder that stores a stack of 95 mm coasters on their edge, with a cutaway at the front so I can slide the top one out with a thumb.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
103 × 30 × 45 mm
Material
PLA
Print Time
3h 5m
Filament
37g
Mesh Faces
572
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Screw-mounted wall hook on a rounded 60x95 mm backplate with five hexagonal cutouts, two countersunk holes and a 45-degree support wedge so it prints flat on its back.
PLA · 4h 5m
Four honeycomb-packed hexagonal cells at staggered heights (95/78/62/50 mm), 1.6 mm walls, chamfered top edges — pens in the tall cell, clips in the short one.
PLA · 8h 10m
Chamfered figure-eight winder with a central 8 mm bore and two 3.2 mm retention slots that pinch the cable ends so the wrap does not unravel in a bag.
PLA · 55m