Chamfered figure-eight winder with a central 8 mm bore and two 3.2 mm retention slots that pinch the cable ends so the wrap does not unravel in a bag.
Chamfered figure-eight winder with a central 8 mm bore and two 3.2 mm retention slots that pinch the cable ends so the wrap does not unravel in a bag.
57.8 × 26 × 8 mm
“Make a small earbud cord winder shaped like a figure eight, with slots at each end that grip the cable so it stays wound in my bag.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
57.8 × 26 × 8 mm
Material
PLA
Print Time
55m
Filament
11g
Mesh Faces
3.1k
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Octagonal weighted base with a hollow hex post, a filleted headband arm at 225 mm, and two front prongs that catch a game controller.
PETG · 24h 35m
Nine 40 mm blank jigsaw pieces laid out as a single print plate, with alternating knobs and 0.15 mm-clearance sockets so they actually snap together.
PLA · 4h 45m
Filleted recessed tray sized to the assembled 3x3 puzzle with 0.6 mm of slack, so finished pieces sit flush and stay together on a shelf.
PLA · 5h 40m