Screw-mounted wall hook on a rounded 60x95 mm backplate with five hexagonal cutouts, two countersunk holes and a 45-degree support wedge so it prints flat on its back.
Screw-mounted wall hook on a rounded 60x95 mm backplate with five hexagonal cutouts, two countersunk holes and a 45-degree support wedge so it prints flat on its back.
60 × 95 × 34 mm
“Make a wall hook with a rounded backplate, a hexagon cutout pattern to save material, two countersunk screw holes, and geometry that prints flat on its back with no supports.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
60 × 95 × 34 mm
Material
PLA
Print Time
4h 5m
Filament
49g
Mesh Faces
1.8k
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Four honeycomb-packed hexagonal cells at staggered heights (95/78/62/50 mm), 1.6 mm walls, chamfered top edges — pens in the tall cell, clips in the short one.
PLA · 8h 10m
Chamfered figure-eight winder with a central 8 mm bore and two 3.2 mm retention slots that pinch the cable ends so the wrap does not unravel in a bag.
PLA · 55m
Octagonal weighted base with a hollow hex post, a filleted headband arm at 225 mm, and two front prongs that catch a game controller.
PETG · 24h 35m