Twelve-sided tapered outer reservoir with a 2.4 mm wall, chamfered rim, pour spout notch, wire pass-through and a sight slot for reading the water level.
This part prints on its own but is designed as one assembly. The other 3 parts:
Twelve-sided tapered outer reservoir with a 2.4 mm wall, chamfered rim, pour spout notch, wire pass-through and a sight slot for reading the water level.
155.1 × 153.8 × 130 mm
“Design the outer reservoir shell for a self-watering planter: a 12-sided tapered body about 130 mm tall with a 2.4 mm wall, a pour spout notch in the rim, a wire notch opposite it, and a narrow sight slot so I can see the water level.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
155.1 × 153.8 × 130 mm
Material
PETG
Print Time
18h 10m
Filament
218g
Mesh Faces
228
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Soil pot that hangs from the reservoir rim on a flange, with eight wicking holes in the floor, an integrated 8.8 mm tube channel and a slot for a soil-moisture probe.
PETG · 13h 40m
Hollow distribution ring that sits on the soil and plugs onto the 8.2 mm feed tube, dispersing water through twelve 1.4 mm outlets instead of one stream.
PLA · 45m
Rim-hanging enclosure for a pump relay module, with a filleted shell, chamfered lip, hook that clamps the planter wall and a side slot for wire exit.
PLA · 1h 55m