Soil pot that hangs from the reservoir rim on a flange, with eight wicking holes in the floor, an integrated 8.8 mm tube channel and a slot for a soil-moisture probe.
This part prints on its own but is designed as one assembly. The other 3 parts:
Soil pot that hangs from the reservoir rim on a flange, with eight wicking holes in the floor, an integrated 8.8 mm tube channel and a slot for a soil-moisture probe.
161.5 × 157.8 × 85.5 mm
“Design the inner soil pot for a self-watering planter: it hangs on the reservoir rim by a flange, has wicking holes in the floor, a full-height channel for an 8.2 mm water tube, and a slot in the flange for a soil moisture sensor.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
161.5 × 157.8 × 85.5 mm
Material
PETG
Print Time
13h 40m
Filament
164g
Mesh Faces
6.3k
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Hollow distribution ring that sits on the soil and plugs onto the 8.2 mm feed tube, dispersing water through twelve 1.4 mm outlets instead of one stream.
PLA · 45m
Rim-hanging enclosure for a pump relay module, with a filleted shell, chamfered lip, hook that clamps the planter wall and a side slot for wire exit.
PLA · 1h 55m
Jigsaw-tabbed 95 mm coaster that keys into its neighbours on two edges with a 0.2 mm fit tolerance, with three concentric drip-catch grooves on the face.
PLA · 4h 40m