Hollow distribution ring that sits on the soil and plugs onto the 8.2 mm feed tube, dispersing water through twelve 1.4 mm outlets instead of one stream.
This part prints on its own but is designed as one assembly. The other 3 parts:
Hollow distribution ring that sits on the soil and plugs onto the 8.2 mm feed tube, dispersing water through twelve 1.4 mm outlets instead of one stream.
98 × 82 × 6 mm
“Design a drip ring that sits on the soil of a planter, plugs onto an 8.2 mm water tube, and spreads the water evenly through a dozen small holes around its underside.”
This model was generated from a single sentence using PrintMakerAI's AI engine. No CAD experience required.
Dimensions
98 × 82 × 6 mm
Material
PLA
Print Time
45m
Filament
9g
Mesh Faces
14.9k
Start from the exact prompt that created this model, tweak the dimensions or details, and keep moving.
Rim-hanging enclosure for a pump relay module, with a filleted shell, chamfered lip, hook that clamps the planter wall and a side slot for wire exit.
PLA · 1h 55m
Jigsaw-tabbed 95 mm coaster that keys into its neighbours on two edges with a 0.2 mm fit tolerance, with three concentric drip-catch grooves on the face.
PLA · 4h 40m
Upright caddy sized for a stack of the interlocking coasters, with filleted corners and a front cutaway so the top coaster can be thumbed out.
PLA · 3h 5m