Generate a perfectly fitted, 3D-printable case for your STMicroelectronics STM32 Nucleo-144 F767ZI. Verified 70x133mm base dimensions with Above-board for shield + Morpho header stacking; below-board for solder joints.
Nucleo MCU dissipates 200-500mW depending on clock frequency; ST-LINK section adds ~100mW during active debugging. Passive cooling handles typical workloads.
Development board with ST-LINK attached; PETG for standard builds, PC for industrial.
Two USB connectors on some Nucleo variants (ST-LINK + user USB) — both must be accessible OR one blocked deliberately.
ST-LINK section can be snapped off at the perforated line — do so only if replacing with an external debugger is intended.
Arduino shield headers for ecosystem compat; Morpho headers for full MCU pin access.
Reset button and user button — provide access.
Ethernet RJ-45 jack on the 144-pin board — tall port, requires aperture with strain relief.
Don't waste time with generic STL files that don't fit. Generate a custom, parametric enclosure designed exactly for your STM32 Nucleo-144 F767ZI hardware.
Generate your enclosure now — it's freeJoin 1,000+ makers using AI-powered CAD.
Mechanical properties are estimates. Validate critical loads before use.