Generate a perfectly fitted, 3D-printable case for your Arduino Arduino MKR WiFi 1010. Verified 61.5x25mm base dimensions with Above-board covers pin headers; below-board for LiPo pocket; side for WiFi antenna.
SAMD21 + u-blox NINA-W102 WiFi module dissipate ~250-400mW active — no ventilation needed.
MKR boards target IoT deployments (gateways, data loggers). PETG is default. PC for outdoor/industrial installations where impact resistance matters. ABS for solvent-weld integration.
WiFi antenna (u-blox module integrated) — 10mm metal-free keepout on the antenna-end short edge.
LiPo JST-PH connector — insulate cell from sharp solder joints; strain-relieve the pigtail.
Micro-USB for programming — MUST remain accessible.
MKR form factor has specific pin spacing — matches MKR carriers but NOT Feather/Uno ecosystems.
Don't waste time with generic STL files that don't fit. Generate a custom, parametric enclosure designed exactly for your Arduino MKR WiFi 1010 hardware.
Generate your enclosure now — it's freeJoin 1,000+ makers using AI-powered CAD.
Mechanical properties are estimates. Validate critical loads before use.